James Hardie Fiber Cement Siding in Kennebunk, Maine

Census estimates put Kennebunk's median home built around 1983, with about 19 percent of the housing predating 1940 and roughly 30 percent predating 1960. The town's oldest and most architecturally significant houses cluster along Summer Street and in the village center, where 18th- and 19th-century sea captains built grand Federal and Greek Revival homes on shipbuilding wealth. Toward Kennebunk Beach and Lower Village, shingle-style cottages and early-20th-century summer homes take over, while the rest of town, further from the water, holds a larger share of capes, colonials and contemporary homes built from the 1970s onward as Kennebunk grew as a year-round community.

Kennebunk Beach, Gooch's Beach and Mother's Beach put the town's southern edge directly on the Atlantic, where nor'easters bring storm surge and wind-driven rain, and salt air speeds the corrosion of fasteners, flashing and gutters faster than it does inland toward the village center. The Kennebunk and Mousam Rivers add a second layer of shoreland exposure further from the coast. Winters bring the usual Maine freeze-thaw cycling, and older, less-insulated attics on Summer Street's historic homes are prone to ice damming at the eaves in a hard winter, same as any older New England house.

Building permits in Kennebunk go through the Code Enforcement Office in the Community Development Department at Town Hall, covering siding, roofing, window and deck work. Because Kennebunk has both river and ocean frontage, Maine's Mandatory Shoreland Zoning Act applies along the Kennebunk and Mousam Rivers and the town's Atlantic coastline, including Kennebunk Beach, Gooch's Beach and Mother's Beach. Exterior work on a Summer Street Historic District property adds a layer of design review that a house elsewhere in town does not face, so that approval is worth confirming before materials are ordered.

Fiber cement is a mix of cement, sand and cellulose fiber pressed into planks, shingles and panels. It does not rot, insects do not eat it, it will not burn, and factory-applied finishes hold color far longer than site-painted wood. It is heavier and more exacting to install than vinyl, which is exactly why installation quality shows. The Back Cove home on this site was re-sided with a complete James Hardie package of wood-grain plank.

• Walls are stripped, repaired and wrapped, with flashing at every opening and roof-to-wall joint.
• Boards are cut with dust-controlled tools and fastened to the manufacturer's nailing schedule.
• Required clearances are held above roofs, decks and grade so the ends never sit in water or snow.
• Butt joints get flashing behind them, and cut ends are sealed or primed as the manufacturer specifies.
• Trim, caulk lines and touch-up are finished so the pre-finished color stays uniform.

• You want the look of painted clapboard without the paint cycle
• Wood siding keeps rotting at the bottom courses and around trim
• The house sits in wind and salt exposure that punishes other materials
• You want a non-combustible exterior

• Product line and profile: lap plank, shingle, panel or board-and-batten
• Pre-finished color versus site painting
• Trim package and detailing
• Tear-off, sheathing repair and house height
• Number of windows, doors and corners to flash and trim

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the James Hardie fiber cement siding overview.

For a deeper walkthrough of materials, code details and photos, see our full James Hardie Fiber Cement Siding: Why It Holds Up Through a Maine Freeze-Thaw Cycle guide.

Back to the Kennebunk exterior services overview, or see every town on our service areas page.