Metal Roofing in Kennebunk, Maine

Census estimates put Kennebunk's median home built around 1983, with about 19 percent of the housing predating 1940 and roughly 30 percent predating 1960. The town's oldest and most architecturally significant houses cluster along Summer Street and in the village center, where 18th- and 19th-century sea captains built grand Federal and Greek Revival homes on shipbuilding wealth. Toward Kennebunk Beach and Lower Village, shingle-style cottages and early-20th-century summer homes take over, while the rest of town, further from the water, holds a larger share of capes, colonials and contemporary homes built from the 1970s onward as Kennebunk grew as a year-round community.

Kennebunk Beach, Gooch's Beach and Mother's Beach put the town's southern edge directly on the Atlantic, where nor'easters bring storm surge and wind-driven rain, and salt air speeds the corrosion of fasteners, flashing and gutters faster than it does inland toward the village center. The Kennebunk and Mousam Rivers add a second layer of shoreland exposure further from the coast. Winters bring the usual Maine freeze-thaw cycling, and older, less-insulated attics on Summer Street's historic homes are prone to ice damming at the eaves in a hard winter, same as any older New England house.

Building permits in Kennebunk go through the Code Enforcement Office in the Community Development Department at Town Hall, covering siding, roofing, window and deck work. Because Kennebunk has both river and ocean frontage, Maine's Mandatory Shoreland Zoning Act applies along the Kennebunk and Mousam Rivers and the town's Atlantic coastline, including Kennebunk Beach, Gooch's Beach and Mother's Beach. Exterior work on a Summer Street Historic District property adds a layer of design review that a house elsewhere in town does not face, so that approval is worth confirming before materials are ordered.

Metal roofs shed snow, shrug off wind, and outlast most other roofing. Standing seam panels run from eave to ridge with raised, concealed-fastener seams; metal shingle systems give a more traditional look. The site lists metal roofing systems among its roofing options. Because snow slides off metal in sheets, planning where it lands, over doors, walks, decks and lower roofs, is part of the design.

• Tear-off to the deck and repair, or preparation of the existing deck as the system requires.
• High-temperature underlayment and ice and water protection where needed.
• Panels or metal shingles installed with clips or fasteners that allow thermal movement.
• Trim, ridge, eave and valley flashings formed and installed.
• Snow guards placed where sliding snow would land on entries, decks or lower roofs.

• You want the last roof you put on the house
• Heavy snow loads and ice dams on a low-pitch or shaded roof
• A camp, barn or outbuilding where low upkeep matters most
• Repeated shingle blow-offs in wind

• Standing seam versus metal shingle, and gauge and finish
• Roof area, pitch and number of penetrations
• Tear-off and deck preparation
• Snow guard layout
• Trim, valley and flashing detail

Every job is priced from a free on-site visit. Typical ranges for the trade are on our roofing page, and the details of this service are on the metal roofing overview.

For a deeper walkthrough of materials, code details and photos, see our full Metal Roofing: Standing Seam, Snow Shedding, and Panel Lifespan in Maine guide.

Back to the Kennebunk exterior services overview, or see every town on our service areas page.