Vinyl Siding Installation in Wells, Maine

Census estimates put Wells' median home built around 1989, the newest housing stock among the towns in this service area, with only about 8 percent of homes predating 1940 and roughly 18 percent predating 1960. Most of Wells' housing was built from the 1960s onward, as the town grew along its beaches and the Route 1 corridor rather than around an older mill or shipbuilding economy. Beach cottages at Wells Beach, Moody Beach and Drakes Island Beach range from smaller older camps to larger, newer builds raised up on pilings, while inland neighborhoods hold a straightforward mix of capes, ranches and contemporary homes.

With seven miles of Atlantic coastline, Wells takes nor'easters and wind-driven rain directly along its entire beachfront, and salt air corrodes fasteners, flashing and roofing hardware faster near Wells Beach, Moody Beach and Drakes Island than it does along the inland stretches of Route 1. The Rachel Carson National Wildlife Refuge and the Wells National Estuarine Research Reserve at Laudholm Farm add extensive marsh and tidal frontage to the town's exposure profile. Winters bring standard Maine freeze-thaw cycling and snow load, and because most of Wells' housing is newer, ice damming at the eaves is less common here than in towns with an older, less-insulated housing stock.

Building permits in Wells go through the Code Enforcement Office on Sanford Road, covering siding, roofing, window and deck work. Because Wells has roughly seven miles of Atlantic coastline, the town maintains an active Shoreland Overlay Zone plus FEMA Flood Insurance Rate Maps that are directly relevant to construction near the shore, particularly at Wells Beach, Moody Beach and Drakes Island. Properties near the Rachel Carson National Wildlife Refuge or the Wells Reserve at Laudholm Farm can face added shoreland-zoning review given the ecological significance of that land.

Premium vinyl siding is the fastest way to a tight, low-maintenance exterior. Today's thicker panels come in clapboard, Dutch lap, board-and-batten and shake profiles and in colors that were not possible a generation ago. The projects shown on this site include CertainTeed Monogram vinyl siding, used to replace rotting wood clapboards and 1970s metal siding on Portland homes. Vinyl moves with temperature, so how it is hung matters as much as which panel you pick.

• Old siding is removed and the wall is checked for soft sheathing and past leaks.
• House wrap and flashing go on first, with extra care around windows, doors and roof-to-wall joints.
• Starter strip, J-channel and corner posts are set straight and level so every course lines up.
• Panels are nailed in the center of the slots and left loose enough to expand and contract through a Maine winter and summer.
• Trim is wrapped or replaced with low-maintenance millwork so there is nothing left to paint.

• You are tired of repainting wood clapboards every few years
• The existing vinyl is faded, cracked, or loose after wind storms
• The budget needs a whole-house result rather than one premium wall
• You want an insulated panel to take the edge off drafty walls

• Panel grade and thickness, and whether it is insulated
• Profile: clapboard, Dutch lap, board-and-batten or shake
• Amount of trim, soffit and fascia wrapped or replaced
• Tear-off and sheathing repairs
• House height and access

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the vinyl siding installation overview.

For a deeper walkthrough of materials, code details and photos, see our full Vinyl Siding Installation: Built to Move With a Maine Winter guide.

Back to the Wells exterior services overview, or see every town on our service areas page.