Window Replacement in Wells, Maine

Census estimates put Wells' median home built around 1989, the newest housing stock among the towns in this service area, with only about 8 percent of homes predating 1940 and roughly 18 percent predating 1960. Most of Wells' housing was built from the 1960s onward, as the town grew along its beaches and the Route 1 corridor rather than around an older mill or shipbuilding economy. Beach cottages at Wells Beach, Moody Beach and Drakes Island Beach range from smaller older camps to larger, newer builds raised up on pilings, while inland neighborhoods hold a straightforward mix of capes, ranches and contemporary homes.

Wells' identity runs along its beaches: Wells Beach, Moody Beach and Drakes Island Beach draw a mix of year-round residents and seasonal owners to cottages and newer homes built up close to the sand. Inland, the Route 1 corridor carries the town's commercial strip and a broad range of residential neighborhoods built out over the second half of the 20th century. The Rachel Carson National Wildlife Refuge and the Wells Reserve at Laudholm Farm preserve large stretches of salt marsh and dune along the coast, giving Wells more protected shoreline than most towns its size.

Building permits in Wells go through the Code Enforcement Office on Sanford Road, covering siding, roofing, window and deck work. Because Wells has roughly seven miles of Atlantic coastline, the town maintains an active Shoreland Overlay Zone plus FEMA Flood Insurance Rate Maps that are directly relevant to construction near the shore, particularly at Wells Beach, Moody Beach and Drakes Island. Properties near the Rachel Carson National Wildlife Refuge or the Wells Reserve at Laudholm Farm can face added shoreland-zoning review given the ecological significance of that land.

A new window is only as good as the way it is set into the wall. Replacement windows go in either as inserts inside the existing frame or as full-frame units after the old frame comes out; the right choice depends on the condition of the frame, the trim you want to keep, and the siding around it. The site lists vinyl replacement windows and wood or clad units from Andersen, Marvin, Pella and Integrity, in double-hung, casement, picture, bay, sliding and awning styles.

• Each opening is measured and checked for rot in the sill, jambs and framing.
• Old sashes or whole frames come out; damaged wood is repaired before the new unit goes in.
• Units are set level, plumb and square, shimmed, and fastened as the manufacturer requires.
• Low-expansion foam and backer rod seal the gap without bowing the frame.
• Flashing, exterior trim or capping and interior casing are finished so the opening sheds water.

• Fog or condensation between the panes of insulated glass
• Sashes that stick, will not stay up, or let in drafts
• Soft or rotted sills and frames
• Single-pane glass or storm windows you take on and off every year
• Frost or ice on the inside of the glass in winter

• Number of windows, their sizes, and any custom shapes
• Vinyl versus wood or clad units, and the brand and series
• Insert versus full-frame replacement
• Glass package and grille options
• Interior and exterior trim work, and whether siding is open around the opening

Every job is priced from a free on-site visit. Typical ranges for the trade are on our window replacement page, and the details of this service are on the window replacement overview.

For a deeper walkthrough of materials, code details and photos, see our full Window Replacement: U-Factor, ENERGY STAR, and Full-Frame vs. Insert in Maine guide.

Back to the Wells exterior services overview, or see every town on our service areas page.