Window Replacement in Kennebunkport, Maine

Census estimates put Kennebunkport's median home built around 1982, with about 13 percent of the housing predating 1940 and roughly 29 percent predating 1960, on a year-round population of well under 4,000 that swells considerably each summer. The town's defining houses are the early-1900s shingle-style cottages of the Cape Arundel Summer Colony, running from Chick's Creek toward Walker's Point, built as grand seasonal retreats rather than year-round homes. Cape Porpoise, the town's working fishing harbor, holds a more modest mix of older cottages and captain's houses, while Goose Rocks Beach and the town's inland areas add a range of newer, more ordinary coastal homes built through the second half of the 20th century.

The Cape Arundel Summer Colony Historic District holds a concentration of early-1900s shingle-style 'cottages,' including Walker's Point, the Bush family's well-known summer estate, running along the shore from Chick's Creek toward the point. Cape Porpoise is a genuine working harbor village with lobster boats, a small commercial fleet and older captain's houses clustered close to the water. Dock Square anchors the town's small commercial center near the Kennebunk River, and Goose Rocks Beach, on the town's northern edge, holds a quieter stretch of beach cottages away from the busier summer colony.

Building permits in Kennebunkport go through the Planning and Development Department's Code Enforcement Office at Town Hall on Elm Street. With a population under Maine's 4,000-resident threshold, Kennebunkport is not required to enforce the statewide Maine Uniform Building and Energy Code, though the plumbing and general permitting process still applies to every exterior job here. Because the whole town sits on the coast, the Kennebunkport shoreline falls under Maine's Mandatory Shoreland Zoning Act, and the town maintains a separate Flood Hazard Development Permit for construction in shoreland and flood-zone areas, plus added review inside the Cape Arundel Summer Colony Historic District.

A new window is only as good as the way it is set into the wall. Replacement windows go in either as inserts inside the existing frame or as full-frame units after the old frame comes out; the right choice depends on the condition of the frame, the trim you want to keep, and the siding around it. The site lists vinyl replacement windows and wood or clad units from Andersen, Marvin, Pella and Integrity, in double-hung, casement, picture, bay, sliding and awning styles.

• Each opening is measured and checked for rot in the sill, jambs and framing.
• Old sashes or whole frames come out; damaged wood is repaired before the new unit goes in.
• Units are set level, plumb and square, shimmed, and fastened as the manufacturer requires.
• Low-expansion foam and backer rod seal the gap without bowing the frame.
• Flashing, exterior trim or capping and interior casing are finished so the opening sheds water.

• Fog or condensation between the panes of insulated glass
• Sashes that stick, will not stay up, or let in drafts
• Soft or rotted sills and frames
• Single-pane glass or storm windows you take on and off every year
• Frost or ice on the inside of the glass in winter

• Number of windows, their sizes, and any custom shapes
• Vinyl versus wood or clad units, and the brand and series
• Insert versus full-frame replacement
• Glass package and grille options
• Interior and exterior trim work, and whether siding is open around the opening

Every job is priced from a free on-site visit. Typical ranges for the trade are on our window replacement page, and the details of this service are on the window replacement overview.

For a deeper walkthrough of materials, code details and photos, see our full Window Replacement: U-Factor, ENERGY STAR, and Full-Frame vs. Insert in Maine guide.

Back to the Kennebunkport exterior services overview, or see every town on our service areas page.