Metal Roofing in Old Orchard Beach, Maine

Census estimates put Old Orchard Beach's median home built around 1982, with about 23 percent of the housing predating 1940 and roughly 31 percent predating 1960. Much of the town's older stock sits close to the beach and the pier, where small cottages and converted motels have been rebuilt and re-clad repeatedly over decades of storm exposure and changing ownership. Ocean Park, the historic Chautauqua-era summer community on the town's south end, holds a cluster of older cottages with more traditional New England detailing. Away from the immediate shorefront, Old Orchard Beach's year-round neighborhoods run to more ordinary capes and ranches typical of coastal York County.

Old Orchard Beach's whole identity runs on its beach, and that same beach means every house near the water takes nor'easters, storm surge and wind-driven rain with very little between it and the open Atlantic. The town's shoreland rules recognize this with a Highest Annual Tide overlay in areas like Ocean Park, on top of the standard shoreland zone. Salt air corrodes fasteners, flashing and gutters faster near the water than a few blocks inland, and winter brings the same freeze-thaw cycling and snow load as the rest of coastal Maine, with wind exposure that is sharper right along the beachfront.

Building permits in Old Orchard Beach go through the Code Enforcement Department at the Town Hall on Portland Avenue, covering building, electrical, plumbing and sewer-connection work through one office. Because the whole town sits on the coast, a Shoreland Overlay Zone extends 250 feet from the ocean's normal high-water line, with a stricter Highest Annual Tide overlay layered on top in areas like Ocean Park, both of which affect how close new construction and rebuilding can sit to the water. Not every property is on the town's municipal sewer system, so some permits still reference individual septic systems.

Metal roofs shed snow, shrug off wind, and outlast most other roofing. Standing seam panels run from eave to ridge with raised, concealed-fastener seams; metal shingle systems give a more traditional look. The site lists metal roofing systems among its roofing options. Because snow slides off metal in sheets, planning where it lands, over doors, walks, decks and lower roofs, is part of the design.

• Tear-off to the deck and repair, or preparation of the existing deck as the system requires.
• High-temperature underlayment and ice and water protection where needed.
• Panels or metal shingles installed with clips or fasteners that allow thermal movement.
• Trim, ridge, eave and valley flashings formed and installed.
• Snow guards placed where sliding snow would land on entries, decks or lower roofs.

• You want the last roof you put on the house
• Heavy snow loads and ice dams on a low-pitch or shaded roof
• A camp, barn or outbuilding where low upkeep matters most
• Repeated shingle blow-offs in wind

• Standing seam versus metal shingle, and gauge and finish
• Roof area, pitch and number of penetrations
• Tear-off and deck preparation
• Snow guard layout
• Trim, valley and flashing detail

Every job is priced from a free on-site visit. Typical ranges for the trade are on our roofing page, and the details of this service are on the metal roofing overview.

For a deeper walkthrough of materials, code details and photos, see our full Metal Roofing: Standing Seam, Snow Shedding, and Panel Lifespan in Maine guide.

Back to the Old Orchard Beach exterior services overview, or see every town on our service areas page.