Metal Roofing in Scarborough, Maine

Census estimates for 2020 to 2024 put Scarborough at about 11,100 housing units with a median year built of 1988, a young housing stock for a town settled in 1635. About 30 percent of homes date from 2000 or later and roughly another 31 percent from the 1980s and 1990s, so a large share of houses are reaching the age when original roofs, builder-grade windows and first-generation siding come due together. About 24 percent went up between 1960 and 1979. The older layer is thinner but distinctive: about 16 percent of homes predate 1960 and about 8 percent predate 1940, including the summer cottages of Prouts Neck, many of which have changed little in more than a century. Roughly 69 percent of homes are single-family detached, about 77 percent of occupied homes are owner-occupied, and some 850 units are held for seasonal use.

Scarborough faces Saco Bay and the open Gulf of Maine, and much of the town sits close to sea level, with an average elevation of about 20 feet and a high point of roughly 215 feet on Beech Ridge. Houses at Prouts Neck, Pine Point and Higgins Beach take wind and salt spray straight off the water, and winter nor'easters bring high winds, driving rain and snowfalls that often top a foot. The Portland International Jetport, a few miles away, averages close to 69 inches of snow a year, though totals swing widely from one winter to the next. Homes along the marsh sit on low, open ground where wind crosses the flats. Everywhere, repeated freezing and thawing works water into joints, sills and shingle edges.

Building permits in Scarborough go through the Code Enforcement division of the Planning and Codes Department, which applies the 2021 Maine Uniform Building and Energy Code and its residential code. The town's code FAQ says anyone who intends to construct, alter or repair a building must first obtain the required permit, so new decks and deck replacements are permitted before work starts; ask the office about roofing, siding and windows. Lots near the shore, marsh or rivers fall under Shoreland Zoning Ordinance 405C, and any development in a FEMA Special Flood Hazard Area needs a flood hazard permit, a condition of the town's membership in the National Flood Insurance Program.

Metal roofs shed snow, shrug off wind, and outlast most other roofing. Standing seam panels run from eave to ridge with raised, concealed-fastener seams; metal shingle systems give a more traditional look. The site lists metal roofing systems among its roofing options. Because snow slides off metal in sheets, planning where it lands, over doors, walks, decks and lower roofs, is part of the design.

• Tear-off to the deck and repair, or preparation of the existing deck as the system requires.
• High-temperature underlayment and ice and water protection where needed.
• Panels or metal shingles installed with clips or fasteners that allow thermal movement.
• Trim, ridge, eave and valley flashings formed and installed.
• Snow guards placed where sliding snow would land on entries, decks or lower roofs.

• You want the last roof you put on the house
• Heavy snow loads and ice dams on a low-pitch or shaded roof
• A camp, barn or outbuilding where low upkeep matters most
• Repeated shingle blow-offs in wind

• Standing seam versus metal shingle, and gauge and finish
• Roof area, pitch and number of penetrations
• Tear-off and deck preparation
• Snow guard layout
• Trim, valley and flashing detail

Every job is priced from a free on-site visit. Typical ranges for the trade are on our roofing page, and the details of this service are on the metal roofing overview.

For a deeper walkthrough of materials, code details and photos, see our full Metal Roofing: Standing Seam, Snow Shedding, and Panel Lifespan in Maine guide.

Back to the Scarborough exterior services overview, or see every town on our service areas page.