James Hardie Fiber Cement Siding in Sebago, Maine

Census estimates count about 1,520 housing units in Sebago, with a median year built of 1975, older than neighboring Naples. About 17 percent predate 1940 and roughly 36 percent predate 1960. Another 19 percent went up between 1960 and 1979, about a quarter between 1980 and 1999, and about 20 percent in 2000 or later. Some 85 percent are single-family detached houses, and about 89 percent of occupied homes are owner-occupied. Nearly 600 units are held for seasonal use. The town's 2006 comprehensive plan found that most homes along Sebago Lake, Peabody Pond and Barker Pond were seasonal while year-round houses sat away from the water, noted a steady conversion of camps to year-round use since 1991, and counted mobile homes at about 13 percent of the stock, mostly on individual lots rather than in parks.

Sebago is inland lake and hill country, so salt air is not a factor; snow and cold are. The National Weather Service station in nearby Gray records about 84 inches of snow in a normal year, with roughly 20 inches in each of January and February. Elevation adds to the exposure here: Sebago Center sits about 450 feet above sea level, and homes on the slopes toward Douglas Mountain sit higher still. Along the shore, Sebago Lake freezes over completely only every few winters, so wind has miles of open water to build across before it reaches the west-shore camps, and the lake area is known for sudden weather changes in every season. Wooded lots throughout town keep walls and decks shaded and slow to dry.

Permits are handled by the Sebago Code Enforcement and Planning office at 406 Bridgton Road on Route 107, where the Code Enforcement Officer also serves as building inspector and is often out on site visits from noon to 3 p.m. The town's permits page lists building permits, shoreland zoning permits and permit-by-rule forms, and states that no permit is needed for roofing or exterior painting. Siding and window work should be confirmed with the office, and a new deck should be expected to need a building permit. Land within 250 feet of Sebago Lake or a great pond falls under shoreland zoning, which has its own permit form.

Fiber cement is a mix of cement, sand and cellulose fiber pressed into planks, shingles and panels. It does not rot, insects do not eat it, it will not burn, and factory-applied finishes hold color far longer than site-painted wood. It is heavier and more exacting to install than vinyl, which is exactly why installation quality shows. The Back Cove home on this site was re-sided with a complete James Hardie package of wood-grain plank.

• Walls are stripped, repaired and wrapped, with flashing at every opening and roof-to-wall joint.
• Boards are cut with dust-controlled tools and fastened to the manufacturer's nailing schedule.
• Required clearances are held above roofs, decks and grade so the ends never sit in water or snow.
• Butt joints get flashing behind them, and cut ends are sealed or primed as the manufacturer specifies.
• Trim, caulk lines and touch-up are finished so the pre-finished color stays uniform.

• You want the look of painted clapboard without the paint cycle
• Wood siding keeps rotting at the bottom courses and around trim
• The house sits in wind and salt exposure that punishes other materials
• You want a non-combustible exterior

• Product line and profile: lap plank, shingle, panel or board-and-batten
• Pre-finished color versus site painting
• Trim package and detailing
• Tear-off, sheathing repair and house height
• Number of windows, doors and corners to flash and trim

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the James Hardie fiber cement siding overview.

For a deeper walkthrough of materials, code details and photos, see our full James Hardie Fiber Cement Siding: Why It Holds Up Through a Maine Freeze-Thaw Cycle guide.

Back to the Sebago exterior services overview, or see every town on our service areas page.