James Hardie fiber cement siding on a Back Cove, Portland home by Cardinal Exteriors

James Hardie Fiber Cement Siding in Standish, Maine

James Hardie Fiber Cement Siding for Standish homes from a family-owned Portland company. An owner measures on site and writes a fixed-price proposal.

  • Google reviews
  • Fully licensed & insured
  • Free estimates
  • 20+ years combined experience

James Hardie Fiber Cement Siding for Standish homes

James Hardie fiber cement is a strong match for the older houses in Standish. Roughly 28 percent of the town's homes were built before 1960, including village houses around Standish Corner and Steep Falls that date from an era when painted wood siding was the norm. Fiber cement comes in a smooth or wood-grain lap profile with a painted finish, so it keeps the look of those older walls while standing up to the freeze-thaw cycles and damp shade that break down wood over time.

It also answers two concerns specific to a rural, wooded town. Fiber cement will not burn, which matters on houses backed by forest or set close to a neighbor's woodpile, and it gives woodpeckers and insects nothing to work on. The boards are heavy and must be installed with correct clearances above roofs, decks and grade, which is especially important on lake camps that sit low to the ground where snow piles against the walls every winter. Factory-applied color holds well in the strong summer sun that reflects off Sebago, and a well-installed wall needs paint far less often than wood clapboard does. Cardinal gives a written fixed price after an owner measures the house.

Fiber cement siding meeting the roofline on a new-construction Yarmouth home

How a Siding Wall Assembly Works

  1. Sheathing — the structural wall surface everything else attaches to
  2. Weather-resistive barrier — a wrapped membrane that stops bulk water while letting vapor escape
  3. Rainscreen gap — a drainage and drying space between the barrier and the siding
  4. Siding — the visible cladding, fastened over the furring strips
  5. Window flashing — tucked under the barrier above and lapped over the siding below, so water never gets behind it
Fiber cement clapboard-style siding on a Portland-area commercial building

Standish housing at a glance

Census estimates put Standish at about 4,900 housing units, with a median year built of 1980. Roughly 17 percent of homes date from before 1940 and about 28 percent from before 1960, while about 22 percent went up between 1960 and 1979 and roughly 23 percent since 2000. This is a town of owners living in detached houses: about 91 percent of occupied homes are owner-occupied and about 86 percent of all units are single-family detached. Around 950 units are held for seasonal use, many of them camps and cottages on Sebago Lake, Watchic Lake and the town's smaller ponds. The town's own 2006 comprehensive plan notes that many seasonal owners come from out of state and use their places on weekends all year. The oldest houses cluster along Route 25 at Standish Corner, and the town allows individual mobile and manufactured homes on house lots.

Weather and exposure in Standish

Standish is inland, but more than a quarter of its area is water, and that shapes how houses weather. Lakefront homes on Sebago take a long open fetch of wind across the water, and the lake region is known for sudden weather changes in every season. Away from the shore, homes sit in woods and fields where shade keeps north walls and roofs damp. Winters are cold: at the Portland Jetport, the nearest long-record station, snowfall averages about 69 inches a year on 1991 to 2020 normals, and January lows average near 16 degrees. Repeated freeze-thaw cycles work water into siding joints, deck boards and roof edges, and heavy wet snow on shallow porch and camp roofs is a recurring load every winter here.

Permits and design review in Standish

Building permits in Standish come from the Code Enforcement office at the Municipal Building on Northeast Road. The town requires footing, framing and final inspections, and the permit holder must call for each one; permits run two years. For bedroom windows, the office lists the residential code's egress rules: a sill no higher than 44 inches and at least 5.7 square feet of net clear opening. Lots within 250 feet of Sebago, Watchic, the Saco or the Presumpscot fall under shoreland zoning, which has its own application through the Planning office. Standish Corner has a local historic district, so ask the Planning office first.

Standish at a Glance

What the housing stock and local code enforcement mean for a siding, window, roofing or deck job here.

10,244

Population (ACS estimate)

Median year built: 1980

Homes built before 194017%

Mostly vinyl or fiber-cement siding and insulated replacement windows from recent decades.

State Building & Energy Code (MUBEC)

Enforced — population over 4,000

EPA Lead-Safe Rule (pre-1978 homes)

Applies to at least 28% of homes here

Shoreland Zoning

Applies near the water

Permits

Town of Standish Code Enforcement Office

Codes & Permits for Fiber Cement Siding in Standish

In Standish, exterior-work permits come from the Town of Standish Code Enforcement Office (175 Northeast Road (Route 35), Standish, ME 04084, 207-642-4571). With 10,244 residents, over 4,000, Standish is required to enforce the Maine Uniform Building and Energy Code (MUBEC).

  • Maine's adopted 2021 IRC (R703.10) requires fiber-cement siding products to be installed per the manufacturer's instructions, with fasteners penetrating a minimum of 1.5 inches into framing when installed over foam sheathing, per R703.3.4. up.codes
  • General weep-screed/clearance drainage language elsewhere in R703 calls for a minimum 4-inch clearance above earth (2 inches above paved areas) for water-resistive assemblies — the same drainage principle commonly applied to keep fiber-cement board clear of grade/splash-back moisture, though this is a general R703 drainage provision rather than a fiber-cement-specific clearance number. up.codes
  • Maine's Shoreland Zoning Act creates a regulated shoreland zone extending 250 feet (horizontal distance) from the normal high-water line of any great pond, river, or coastal wetland, and 75 feet from certain streams; the Act's stated purposes include protecting buildings and land from flooding/erosion and controlling water pollution, and it governs deck and other structure setbacks and the expansion of nonconforming structures within that zone (specific setback/expansion rules are set at the municipal-ordinance level under the state's model guidelines). maine.gov
  • By Maine law (25 M.R.S. §2373), 'the code must be enforced in a municipality that has more than 4,000 residents' (per the most recent federal census); municipalities at or below that population are not required to adopt/enforce MUBEC but may opt in locally, per the state's own program page: 'All municipalities with a population greater than 4,000 are required, by statute, to enforce the MUBEC. Municipalities with a population under 4,000 may choose to enforce the MUBEC.' mainelegislature.org

How Cardinal Exteriors Handles Fiber Cement Siding in Standish

  • With 10,244 residents, Standish is over Maine's 4,000-resident line, so the town enforces the statewide Uniform Building and Energy Code (MUBEC) on top of its own permit process.
  • At least 28% of Standish's homes predate 1960 — well ahead of 1978, when the EPA's lead-safe renovation rule kicks in — so we plan for lead-safe work practices on James Hardie fiber cement siding whenever painted surfaces come off an older house here.
  • Standish's shoreline, lake or river frontage falls under Maine's Mandatory Shoreland Zoning Act, so we check setback rules before work starts near the water.
  • We file for James Hardie fiber cement siding permits at the Town of Standish Code Enforcement Office before work starts, not after.
Standish, ME
A pine-lined residential road, Tall Pine Circle, in Standish.
Street View © Google

What James Hardie fiber cement siding involves

Fiber cement is a mix of cement, sand and cellulose fiber pressed into planks, shingles and panels. It does not rot, insects do not eat it, it will not burn, and factory-applied finishes hold color far longer than site-painted wood. It is heavier and more exacting to install than vinyl, which is exactly why installation quality shows. The Back Cove home on this site was re-sided with a complete James Hardie package of wood-grain plank.

  • Walls are stripped, repaired and wrapped, with flashing at every opening and roof-to-wall joint.
  • Boards are cut with dust-controlled tools and fastened to the manufacturer's nailing schedule.
  • Required clearances are held above roofs, decks and grade so the ends never sit in water or snow.
  • Butt joints get flashing behind them, and cut ends are sealed or primed as the manufacturer specifies.
  • Trim, caulk lines and touch-up are finished so the pre-finished color stays uniform.

Signs it is time

  • You want the look of painted clapboard without the paint cycle
  • Wood siding keeps rotting at the bottom courses and around trim
  • The house sits in wind and salt exposure that punishes other materials
  • You want a non-combustible exterior

What affects the price of James Hardie fiber cement siding

  • Product line and profile: lap plank, shingle, panel or board-and-batten
  • Pre-finished color versus site painting
  • Trim package and detailing
  • Tear-off, sheathing repair and house height
  • Number of windows, doors and corners to flash and trim

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the James Hardie fiber cement siding overview.

For a deeper walkthrough of materials, code details and photos, see our full James Hardie Fiber Cement Siding: Why It Holds Up Through a Maine Freeze-Thaw Cycle guide.

Get a free James Hardie fiber cement siding estimate in Standish

Tell us about the house and what you want changed. One of the owners will call to set up a visit, measure, and write a fixed-price proposal. No pressure, no obligation.

Need it today?Call Mike (207) 408-5388

or Bob at (207) 252-0759