James Hardie Fiber Cement Siding in Windham, Maine

Census estimates count about 8,700 housing units in Windham, with a median year built of 1985. Roughly 27 percent of homes were built in 2000 or later, and about 21 percent between 1960 and 1979, while only about 12 percent predate 1940. About 85 percent of occupied homes are owner-occupied and roughly 79 percent of units are single-family detached. Around 780 units are held for seasonal use. The town's 2017 comprehensive plan notes that many once-seasonal camps around the lakes are now lived in year-round, still reached by old gravel roads built for summer use. It also records that Windham's population held near 2,000 from 1830 to 1940, so most of today's houses belong to the decades of growth that followed.

Windham sits inland, so salt spray is not the main enemy here; snow, cold and lake wind are. Homes on Sebago Lake near Jordan Bay face a long reach of open water, and the lake region is known for sudden weather changes in every season. Houses on Little Sebago, Highland Lake and the town's smaller ponds sit among trees that keep walls shaded and damp. The Portland Jetport, the nearest long-record weather station, averages about 69 inches of snow a year on 1991 to 2020 normals, with January lows near 16 degrees. Frequent thaws and refreezes through the winter push water into siding laps, roof edges and deck framing.

Windham's Code Enforcement department, at 8 School Road, administers the town's land use, building, plumbing and electrical codes, and permits are applied for through the town's online portal. Decks are structural work, so check permit needs there before building one. Properties within 250 feet of Sebago Lake, Little Sebago, Highland Lake, the Presumpscot or the Pleasant River fall under shoreland zoning, which the town administers and which limits building near the water. Windham adopted a historic preservation ordinance in 1989, but its 2017 plan says no local historic district boundaries were ever put in place.

Fiber cement is a mix of cement, sand and cellulose fiber pressed into planks, shingles and panels. It does not rot, insects do not eat it, it will not burn, and factory-applied finishes hold color far longer than site-painted wood. It is heavier and more exacting to install than vinyl, which is exactly why installation quality shows. The Back Cove home on this site was re-sided with a complete James Hardie package of wood-grain plank.

• Walls are stripped, repaired and wrapped, with flashing at every opening and roof-to-wall joint.
• Boards are cut with dust-controlled tools and fastened to the manufacturer's nailing schedule.
• Required clearances are held above roofs, decks and grade so the ends never sit in water or snow.
• Butt joints get flashing behind them, and cut ends are sealed or primed as the manufacturer specifies.
• Trim, caulk lines and touch-up are finished so the pre-finished color stays uniform.

• You want the look of painted clapboard without the paint cycle
• Wood siding keeps rotting at the bottom courses and around trim
• The house sits in wind and salt exposure that punishes other materials
• You want a non-combustible exterior

• Product line and profile: lap plank, shingle, panel or board-and-batten
• Pre-finished color versus site painting
• Trim package and detailing
• Tear-off, sheathing repair and house height
• Number of windows, doors and corners to flash and trim

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the James Hardie fiber cement siding overview.

For a deeper walkthrough of materials, code details and photos, see our full James Hardie Fiber Cement Siding: Why It Holds Up Through a Maine Freeze-Thaw Cycle guide.

Back to the Windham exterior services overview, or see every town on our service areas page.