James Hardie Fiber Cement Siding in Westbrook, Maine

The Census Bureau's 2020-2024 American Community Survey estimates about 9,580 housing units in Westbrook, with a median year built of 1975. The stock splits into two eras. About a quarter of homes were built before 1940 and roughly 37 percent before 1960, while close to a quarter were built in 2000 or later, reflecting the city's recent growth. Only about 44 percent of units are single-family detached houses; the rest are duplexes, apartment buildings, condominiums and other attached housing. Around 61 percent of occupied homes are owner-occupied. The older layer includes the mill housing inside the Cumberland Mills Historic District and wood-frame homes like the 1914 Vallee Family House on Monroe Avenue, a clapboard American Foursquare with a hip roof and full front porch.

Westbrook sits a few miles inland from Casco Bay at an elevation of about 105 feet, so it misses most of the direct salt spray that coastal towns deal with but gets the full weight of southern Maine winters. Portland, on the city's eastern border, averages about 69 inches of snow a year, with seasons ranging far above and below that, and nor'easters regularly bring a foot or more with strong wind. Away from the ocean's moderating influence, nights run colder, frost goes deeper and freeze-thaw cycles work hard on roofs, flashing and deck footings. The city's own code office sets foundations at four feet below grade for frost protection, a useful benchmark for any new footing.

Westbrook's Code Enforcement Department at City Hall, 2 York Street, issues building permits. The department publishes a building permit application specifically for basic renovations, alterations, sheds and decks, and enforces the Maine Uniform Building and Energy Code: the 2021 International Residential Code and the 2021 International Existing Building Code. Inspections should be booked 48 to 72 hours ahead, and a permit lapses if work does not start within six months. The city also has a Flood Hazard Permit for work in mapped flood zones, and lots near the Presumpscot River may fall within Maine's mandatory shoreland zone, which covers land within 250 feet of a river.

Fiber cement is a mix of cement, sand and cellulose fiber pressed into planks, shingles and panels. It does not rot, insects do not eat it, it will not burn, and factory-applied finishes hold color far longer than site-painted wood. It is heavier and more exacting to install than vinyl, which is exactly why installation quality shows. The Back Cove home on this site was re-sided with a complete James Hardie package of wood-grain plank.

• Walls are stripped, repaired and wrapped, with flashing at every opening and roof-to-wall joint.
• Boards are cut with dust-controlled tools and fastened to the manufacturer's nailing schedule.
• Required clearances are held above roofs, decks and grade so the ends never sit in water or snow.
• Butt joints get flashing behind them, and cut ends are sealed or primed as the manufacturer specifies.
• Trim, caulk lines and touch-up are finished so the pre-finished color stays uniform.

• You want the look of painted clapboard without the paint cycle
• Wood siding keeps rotting at the bottom courses and around trim
• The house sits in wind and salt exposure that punishes other materials
• You want a non-combustible exterior

• Product line and profile: lap plank, shingle, panel or board-and-batten
• Pre-finished color versus site painting
• Trim package and detailing
• Tear-off, sheathing repair and house height
• Number of windows, doors and corners to flash and trim

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the James Hardie fiber cement siding overview.

For a deeper walkthrough of materials, code details and photos, see our full James Hardie Fiber Cement Siding: Why It Holds Up Through a Maine Freeze-Thaw Cycle guide.

Back to the Westbrook exterior services overview, or see every town on our service areas page.