James Hardie Fiber Cement Siding in New Gloucester, Maine

Census estimates put New Gloucester at about 2,260 housing units with a median year built of 1991. About 11 percent of homes predate 1940 and roughly one in five predates 1960, but the largest share, about 31 percent, has been built in 2000 or later. Only about 15 percent date from 1960 to 1979, a much thinner mid-century layer than in neighboring Gray. Around 70 percent of units are single-family detached houses, and about 83 percent of occupied homes are owner-occupied. Seasonal homes are rare, about two dozen by the survey's count, so nearly every house here is lived in year-round. The oldest houses are notable: the village holds many wood-frame houses built before 1810 in Georgian and Federal styles, and Intervale Farm's circa-1811 brick farmhouse is joined to its barn by a string of wood-frame additions.

New Gloucester is inland farm country, with the town center at roughly 364 feet and no salt exposure. The nearest long-term record is next door: NOAA's 1991-2020 normals for the Gray station list about 84 inches of snow a year, and January there averages near 22 degrees. The town's own code enforcement handout gives the figures it builds to, a total snow load of 70 pounds per square foot and a 100 mph wind speed. Open fields along the Intervale and around the farms let wind drive snow and rain against the long walls of connected farmhouses, and repeated freeze-thaw cycles work into any joint that holds water.

New Gloucester's Code Enforcement Officer, who also serves as plumbing inspector and health officer, issues building permits. Under Article 6.1.1 of the zoning ordinance, no structure may be erected, moved, added to or structurally altered without one. The office's handout says regular maintenance such as roofing, siding and window replacement needs no permit when it does not alter the structure. Decks do: the permit checklist asks for a foundation plan, framing cross sections and a signed plot plan with setbacks. The town's FAQ notes that work within 100 feet of a water body may need Maine DEP approval.

Fiber cement is a mix of cement, sand and cellulose fiber pressed into planks, shingles and panels. It does not rot, insects do not eat it, it will not burn, and factory-applied finishes hold color far longer than site-painted wood. It is heavier and more exacting to install than vinyl, which is exactly why installation quality shows. The Back Cove home on this site was re-sided with a complete James Hardie package of wood-grain plank.

• Walls are stripped, repaired and wrapped, with flashing at every opening and roof-to-wall joint.
• Boards are cut with dust-controlled tools and fastened to the manufacturer's nailing schedule.
• Required clearances are held above roofs, decks and grade so the ends never sit in water or snow.
• Butt joints get flashing behind them, and cut ends are sealed or primed as the manufacturer specifies.
• Trim, caulk lines and touch-up are finished so the pre-finished color stays uniform.

• You want the look of painted clapboard without the paint cycle
• Wood siding keeps rotting at the bottom courses and around trim
• The house sits in wind and salt exposure that punishes other materials
• You want a non-combustible exterior

• Product line and profile: lap plank, shingle, panel or board-and-batten
• Pre-finished color versus site painting
• Trim package and detailing
• Tear-off, sheathing repair and house height
• Number of windows, doors and corners to flash and trim

Every job is priced from a free on-site visit. Typical ranges for the trade are on our siding page, and the details of this service are on the James Hardie fiber cement siding overview.

For a deeper walkthrough of materials, code details and photos, see our full James Hardie Fiber Cement Siding: Why It Holds Up Through a Maine Freeze-Thaw Cycle guide.

Back to the New Gloucester exterior services overview, or see every town on our service areas page.